|
Tractor Talk Discussion Board |
Re: Re: Re: Displacement/engine speed/HP
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken McWilliams on September 01, 2000 at 17:29:01 from (172.140.39.185):
In Reply to: Re: Re: Displacement/engine speed/HP posted by John H. on September 01, 2000 at 06:16:39:
Dr. John, I don't use it often. The HCl will be more corrosive to the aluminum pistons than to the steel and iron. I reality, a few salts dissolved in water condensate will set up a electolytic cell in a cylinder and form galvanic corrosion to a greater extent. This is what most destroys engines when not put to use. I tore apart a CASE engine 2 years ago that was seized. It took about 45 - 60 minutes per piston to break the rings out of the piston grooves and clean them. The white powder filled all the gaps. Ken McWilliams
Dayton, OH
Follow Ups:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
