Re: Best way to get small dents out of the thinner sheet metal?

Posted by Fred OH on September 01, 2000 at 07:17:44 from (208.32.116.24):

In Reply to: Best way to get small dents out of the thinner sheet metal? posted by Roger C. on August 31, 2000 at 22:30:39:

Roger, I don't know for sure about this because I haven't tried it but a fellow says that on car bodies with small dents he takes dry ice and works it from the outside of the dent to the center of it in circular motion. This is supposed to pop the dent right back out.
Has anyone else tried this method or know of it's validity? It kinda sounds too good to be true. But, you never know till it runs through a gauntlet. I just started it, you guys get to do the rest. L8R----Fred

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Best way to get small dents out of the thinner sheet metal? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]