Re: Can't start my Farmall B

Posted by The Red on August 27, 2000 at 15:30:57 from (12.75.197.38):

In Reply to: Can't start my Farmall B posted by Joe Rhodes on August 27, 2000 at 14:14:49:

Joe first of all look at the top of this page where you see "another discussion forum" in the box. Highlight the arrow and you will find the Farmall board.

With the valve cover off and with the #1 cylinder on compression top dead center (make sure you aren't 180 degrees out!) note the position of the rotor. Then turn the distributor so the points are just opening at this point. The distributor cap post that lines up with the rotor will be #1 followed by #3, #4, and #2. in a clockwise manner on the distributor cap. You might have installed it and the rotor is not in the approximate 2 o'clock position from factory installation. Report back with your findings on the Farmall board and welcome aboard!

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Can't start my Farmall B Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]