Posted by 135 Fan on April 18, 2009 at 21:32:32 from (68.149.56.30):
In Reply to: Back in business posted by Billy NY on April 18, 2009 at 20:31:51:
It looks good. It pays to take the time to do it right and prep it like you did. A couple of things you could do if you have another repair. In the first picture you left a notch at the end that could start a crack. Maybe you filled it in later? When you're about to finish your weld, go backwards for a second to fill the crater. Cracks can start at the crater. Even better is to start the weld at each end and overlap the craters in the middle. Cracks don't normally start in the middle and it's easier to start at an edge than finish a weld at the edge, especially if it is thinner or beveled like yours was. Probably was cast steel. Cast iron usually leaves a rougher looking bead. It should hold for 40 acres. Did you use 7018? Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1941 John Deere B Row Crop - by Anthony West (UK). The 1960's promise of white hot technology, to relieve us of the drudgery of everyday work and to replace it with increased leisure time has not materialised just yet....if anything most people are caught up in an ever increasing rat race, wishing that there was at least 36hours in a day!!!. The need for people to escape for periods of relaxation in an increasingly complex and pressured environment takes us into the realm of hobbies. For some it's scaling high mountains for others it's putting p
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
