Posted by tjdub on April 16, 2009 at 09:36:03 from (208.28.88.253):
In Reply to: Safety posted by LenNH on April 16, 2009 at 09:19:03:
I would say just don't go near any spinning shaft. I went to school with one kid that lost his thumb in an auger and another who lost both arms in a self-unloading wagon. Every time I'm anywhere near something spinning I think back to their stories and I have terrible mental images of what would happen if I got sucked in.
There's no reason to be walking over a spinning PTO shaft; Just walk around. Even with a shield, it may not spin as free as you think, plus the U-joints are not shielded much.
That said, I do run some things with bad or no PTO shields. I would replace them if there was a standard part, but unfortunately it means replacing the entire shaft to get a shield the fits. Healthy paranoia and taking your time gives more protection than any shield ever made.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
