Posted by blinwmiaol.com on April 12, 2009 at 08:38:55 from (24.231.255.33):
In Reply to: cow sling posted by chris yoder on April 12, 2009 at 07:08:50:
I feel sorry for you having a cow in that situation. I have dealt with way to many over the years. I will give you the advice to stay as far away from the hip lift that others have desribed. I have used them at different farms in the last 20 years and only seen it work a few times. If you onlly have to lift her once you might be ok with the hip lift but if you have to lift her several times, you might as well call the butcher. The best lift system is one that uses a sort of cradle that goes under the belly ending at the back legs, and has a piece that goes forward between the front legs to lift the brisket too. The ones I have used were made of heavy canvas and once under the cow you slid pipes thru it and lited with the pipes. I am not sure where you could by one but have seen them at several farms as well as out as World Dairy Expo. The best way I have seen for fixing a down cow was using the sling and then getting the cow into a warm water lift tank. We had one of these at the dairy on campus at MSU and it was great for downers. The warm water massaged the cows muscles and nerves while the water level drastically lowered the weight the cows feet would have to carry, so she could stand on her own. It was the closest thing to a miracle for a down cow I have ever seen. Again, I don't know who exactly sells them but I have seen then advertised. Good luck with her.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
