Posted by Tom Upton on April 11, 2009 at 18:33:54 from (24.137.37.126):
In Reply to: Bent Hyd cylinder posted by old on April 11, 2009 at 17:00:01:
Be very carefull when strightening cyl rods. Especialy if they are bent more than 20 degrees.I have personaly seen one break and fly endways out of a 60 ton press. It was a 2 1/2 inch rod about 2 feet long and it flew about 15 feet before it landed! Must have been made from some fairly high carbon steel. Our press has lexan guards front and back but this piece managed to go endways out the side of the press. This being said I would say smaller dia. ag type rods are less likely to break. We have a millwright at work that does the "rougth" staightening in the press, then puts in v blocks on a t slotted table and uses clamps and a dial indicator to get rod usualy within a couple thou.We actualy straighten new turned and ground shafting matl. for specialty jobs as it is usualy not that straight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
