Posted by bruster on March 30, 2009 at 14:18:54 from (65.185.79.186):
In Reply to: C update posted by Lanse on March 30, 2009 at 05:00:09:
Hi Lance Just watched your "test" videos (1&2)Don't have any oil dry or cat litter? My mom would have reamed me out for getting that much oil on the floor! Suggestion Why don't you put an in line shut off valve on your "redneck gas tank", so you won't have to wait for all the gas to drain from the tank? Whether a carb is new or old, the reason that it would leak from the seam would seem like the valve isn't closing. My father taught me to check the float when you rebuild it, BEFORE you stick the top back on the body. Hook up your gas supply (w/ shut off valve!)see if the gas stops and starts when you move the float up and down. I like seeing your progress (or regress, since I've pounded a few tires silly myself)so keep trying......it'll get easier........eventually!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
