Posted by Bob on March 22, 2009 at 11:57:42 from (69.178.228.68):
In Reply to: CASE 310B CLUTCH posted by ks081453 on March 22, 2009 at 11:05:33:
Does the clutch pedal have normal "feel" to it... in other words, is there some free travel followed by resistance as the throwout bearing contacts the clutch release fingers and begins to release the clutch?
I am not familiar with that specific tractor, HOWEVER, most lined clutch discs have to be installed a certain way, USUALLY with the offset of the springs and hub back towards the pressure plate.
Otherwise, if the offset faces forward the offset hub and springs will catch the flywheel-crankshaft bolts and the clutch won't release.
Check the manual to be SURE which way your's is supposed to go, and look for markings such as "flywheel side" on the lined disc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
