Posted by waltdavies on March 17, 2009 at 10:05:12 from (67.142.164.21):
In Reply to: new cam 30wt ND oil posted by CWL on March 17, 2009 at 05:32:09:
We had 6 GMCs with the 350 engine in them. 3 of them had trouble keeping a cam in them always number 5 would go. We took one down an put in everything new except the head and block it still had no oil pressure at idle and lost the cam at 15,000. I would get another block an heads then put your stuff in it you might have better luck, it seems that some blocks were bad an some were not. Use only Detergent oil in any engine or pay the price for it. Old tractors can run on the straight 30 or 40 weight but if you look at the cans they will say detergent or non-detergent on them. Really hard to find non-detergent oils now. Walt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
