Posted by JMOR on March 17, 2009 at 07:10:28 from (76.187.218.177):
In Reply to: new cam 30wt ND oil posted by rustyfarmall on March 17, 2009 at 05:32:09:
CWL said: (quoted from post at 08:32:09 03/17/09) I had a cam go bad in a 400ci ford. The motor is a low mile rebuild. Less than 5000 miles. I have taken it apart cleaned and now I am putting it back together. There was a lot of metal through the engine so I took it down to the bare block and pressure washed it all out including the oil galleys. New cam and lifters, main and rod bearings and a new oil pump have been installed. I have been advised to use 30wt nondetergent oil for the cam break in and maybe for the first 50-100 miles to flush out any metal that I might have missed. I would then change to a quality 10w-30 detergent oil. Are there any pros or cons to using nondetergetn oil for the break in?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
