|
Tractor Talk Discussion Board |
Re: Re: Re: Re: worn hub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MarkB on July 21, 2000 at 15:42:34 from (64.79.86.225):
In Reply to: Re: Re: Re: worn hub posted by chief613 on July 21, 2000 at 02:58:30:
I have to agree with Fred that if you can find another hub at a reasonable price, then that's the way to go. You don't say what kind of tractor you have, but you might want to post a message asking if anyone knows of one in a junkyard. On the other hand, rebuilding your old hub should be a fairly routine repair for any machine shop that fixes a lot of old, obscure and obsolete machinery, which is to say any machine shop that serves farmers. The biggest hub rebuild that I recall was the rear wheel hubs on a LeTourneau "C" Tournapull scraper that my Dad owned years ago. The wheel bearings had spun inside the hub until they were loose. The wheel was about three feet in diameter, so we had to cut the hubs out of the wheels to turn them on the lathe, then weld the whole mess back together.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
