Posted by Brian in Ohio on March 12, 2009 at 18:32:10 from (71.244.241.5):
In Reply to: The allis drives now posted by Lanse on March 12, 2009 at 17:38:22:
Hey Lanse...
Something that you may want to consider before you go to sanding everything by hand with the 40 grit. If you were to use a finer grit, and not remove as much of your brushed on paint, you can get still smooth everything out enough to spray over it, and get a nice finish.
I'd also advise before you start that phase of the project, go over to the Paint and Bodywork discussion board, and get some pointers from CNKS and the other gurus there. They might be able to give you some advice that will help you save time, paint, aggravation, and get the finish you want the first time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
