Posted by Brian Jasper co. Ia on March 11, 2009 at 18:32:17 from (67.142.130.27):
In Reply to: OT Chevy Pickup posted by Chuck NH on March 11, 2009 at 17:05:02:
Sounds like it's loosing battery voltage to the shift solenoids. For second gear, all of the solenoids are off. What DTC's are in the ABS module? I think you may have more than 1 problem. The speedo (IPC)is electronic and if I remember correctly it gets it's signal via serial data from the ABS module. There are several grounds attached to the cab mount right under the driver's feet. One of which is the ground point for the ABS module. They are a common source of trouble for the ABS. If the ABS is going down, that could explain the loss of the speedo and I would expect to see IPC lost communication with ABS module stored in the IPC. Take the ground wires loose and buff them and the spot on the frame shiny clean. Put some die electric grease on the connection between the terminals and the frame, then paint over them with rubberized underbody coating.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.