Tractor Talk Discussion Board |
Re: Re: how to charge a 8 volt battery?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred OH on July 13, 2000 at 09:50:47 from (208.32.116.49):
In Reply to: Re: how to charge a 8 volt battery? posted by Ken McWilliams on July 12, 2000 at 19:52:02:
Hi Ken from Fred, I noticed yesterday on my Ferguson 20 that the battery sparked when I put the last cable on. I figured that the points were closed so I jogged it and tried it again. Same thing, but starts and runs okay. I also noticed that it only put out 6.22 volts from the generator. I need to turn up the regulator to about 7 volts. Which adjustment in the regulator is the voltage adjusting screw? Knowing this will save me from maybe getting it out of whack till I find it. Many thanks, Fred
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|