|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Tractor tip over
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on July 11, 2000 at 22:28:34 from (216.161.109.40):
In Reply to: Re: Re: Re: Tractor tip over posted by Al on July 11, 2000 at 13:07:29:
It's hard to get exact numbers on angles, for one it varies so much with the equipment, air pressure, wheel spacing, etc. etc. plus liability prevents manufacturers from statng a hard number. Likewise liability limits the number of companies willing to build after-market roll over bars. I was mowing the road ditch a few years ago, and a front tire deflated kinda quick. Made the center of gravity, and steering control, change a bit. Got me to thinking, what happens if I hit a pocket gopher hole with the high rear tire, just about the time the low rear tire would go flat? Hum, a person needs a safty margin on this issue. --->Paul
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
1938 John Deere LI
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
