Posted by John B. on March 08, 2009 at 06:50:27 from (38.114.64.131):
Just for those who don't know I ran across this 30 years ago when I bought a set of rear steel wheels for my F14. Well when I got them home they didn't fit my axle. The axle holes were too small, because they were for a Farmall H.
There are 3 differences between the H and F12-14 rear wheels;
"H" wheels have 14 spokes, 1/8" smaller axle diameter and one set screw on each jaw to open the jaws of the center hub that clamps onto the axle.
F12,F14 wheels have 16 spokes, 1/8" bigger axle diameter and both set screws are on the same jaw of the center hub that clamps onto the axle.
Most people just count the spokes but a quick look at the set screws will tell you faster. It beats having to sit there and count spokes.
Hope this helps those who didn't know this when they are looking for a set of steel wheels.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
