Posted by dave2 on February 25, 2009 at 22:29:55 from (139.139.35.70):
In Reply to: OT: Cutting down a 12GA posted by doug in illinois on February 25, 2009 at 15:26:10:
Kelly C said: (quoted from post at 17:24:34 02/25/09) Hmmm. I have a mod 500 wonder if I could just get a barrel for it?
Just google a little.... You can get pistol grip stocks and riot barrels. I had a Stevens 12 ga pump riot control gun when I was a kid. Held 10 shells, and had an 18 in barrel. Paid 25 bucks for it at the time. It was an OK rabbit brush gun but not worth a damn for anything else.
If I had a sawed off shotgun that threw a pattern the size of a pony, my luck the bad guy would be standing close to one of the family and I wouldn't shoot anyway. I'd invest a little in an alarm to discourage them and wake you up, then hit them with a slug from the mossberg if they insist. Why take a chance on them dragging themselves outside and getting you in trouble.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.