Posted by SUPER TRUCKER on February 25, 2009 at 05:53:01 from (75.218.93.254):
In Reply to: Removing broken bolt posted by Mark W. on February 25, 2009 at 05:40:42:
IN MY RUN IN WITH BROKEN BOLTS,IHAVE FOUND DRILLING HARDEN BOLTS JUST PLAIN SUCKS!!!!I FOUND ONCE YOU OVER HEAT THE BOLT IT BECOMES HARDEN AND YOU CAN'T DRILL THEM.I HAD MARGINAL SUCCCESS WITH TITAINIUM COATED BITS AND COBALT BITS.YOUR GOING TO GET REAL GOOD AT SHAPENING BITS ON A GRINDER OR DRILL DOCTOR. OH,LOTS OF CUTTING OIL OR THE LIKE TO KEEP THE BIT COOL.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
