|
Tractor Talk Discussion Board |
Re: Brush hog questions revisited.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on June 25, 2000 at 17:42:00 from (206.228.214.90):
In Reply to: Brush hog questions revisited. posted by Kermit on June 25, 2000 at 11:05:17:
I have attempted to pull my semimount 10 feet Bushog brand rotary cutter with my 574 IH 52 HP fully weighted (front and rear) tractor. I was able to power the rotary cutter but I was not able to handle it as safely as I would like on hilly ground. I feel that 40 HP could handle a pull type cutter in the 8 feet dimension far better than it could handle a 10 feet width machine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
