|
Tractor Talk Discussion Board |
Hydraulic oil filters
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tyler(WA) on June 23, 2000 at 08:03:32 from (12.13.226.14):
I have a MF2135 with a MF99 front end loader. The loader is opperated off a front mount pump. The existing setup has no filters and the fill cap is a pipe cap with a small hole to allow it to breath. The oil is looking pretty dirty. I want to clean the system, replace the hydraulic oil with clean stuff and install filters on the reservoir and the fill cap. Fill cap? A "no-brainer" (buy a replacement cap with a filter) but there are a few models of return line filters and I'm not sure which one I need. I plan to buy from Northern Hydraulic Equipment. There appears to be only one large (1.5"?) hose to the bottom of my reservoir. It does look like there is a tank screen to trap large debris. I assume fluid flows both directions in that large line. Another question - What solvent should I use to clean out the tank debris? If I use diesel, would I have to dry out the tank prior to refilling it with hyd. oil?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
