Posted by Nebraska Cowman on February 23, 2009 at 04:39:45 from (66.252.120.177):
In Reply to: Allis Update-POP posted by Lanse on February 22, 2009 at 18:21:06:
Chucky. There is nothing wrong with your tractor. You need to time the mag right.
FIRST, (this is simple) Take out the #1 spark plug (thats the one at the front, closest to the radiator) Now with your thumb over the spark plug hole have a friend crank the engine over till you feel air pressure on your thumb, (you might have to try this several times to get it right. Once you start to feel some air coming out, STOP cranking. Now, with a piece of wire or something, (I use a screwdriver or my plier handle) poke in the hole and continue craking the engine SLOWLY. You will be able to tell when the piston is at it's verry top. Grab the fan and rock it back and forth a little to be sure it's at the top. (you might want to take all the spark plugs out so it turns easier) NOW....without moving ANYTHING, Take the distributor cap off. See which way the brass piece on the rotor is pointing. That is where the spark is coming from and it needs to get directed to number one cylinder at this time because it is the one that is ready to fire. (Do you understand how a 4 cycle engine works? ) Four strokes, Intake stroke, as the piston goes down, intake valve opens and fuel mixture is sucked in. Compression stroke, both valves closed, piston comes up and squeezes fuel vapor real tight, when at the top of the stroke spark occurs BOOM, Power stroke piston is forced downward by explosion, (I know you understand that) both valves are closed. Exhaust stroke exaust valve opens as piston comes up and burnt gasses are expelled. The other 3 clylinders follow in like manner. In your case 1,2,4,3. Let's see, now, where was I? Oh yeah, The rotor. Look at that pointer piece. Now look at the cap. Is it pointing toward one of the holes in the cap? close to it? before or slighly after? Slightly after is good. Before will break your arm. Stick #1 plug wire in that hole. (nothing else matters at this point, let's get the tractor running first) Now continue in a clockwise direction and insert the other plug wires, 1,2,4,3 and reinstall the spark plugs. Try starting it now. Unless you have had the magneto apart and messed up the internal timing (very easy to do) it shoud at least try to run.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
