Posted by Cub n M in Or on February 22, 2009 at 10:48:00 from (63.174.40.32):
In Reply to: Slaughter Houses posted by Sparktrician on February 21, 2009 at 08:12:56:
When I was a kid we'd schedule our 5 or so beefs to be cut up on a saturday morning. Dad and I would go down to the little butcher shop with the cutting instructions for all the customers, and would watch and tell them exactly what we wanted. The guys that worked there were friends (I ended up dating one of the meat cutters daughters years later), and there was a good bit of BS'n that went along with it. I have alot of fond memories of those days. After a while Dad got to busy to do it so we'd just send the instructions in. Well, we ended up having serious complaints from long time customers that their meat was TERRIBLE. We figured out they were probably selling our nice homegrown grass fed steers at their counter and were buying some old wore out range cow and giving that meat to our customers. Can't very well accuse someone you've been doing business with for 20 years of something like that, so we switched butchers. Never had the problem again. The shop that we had been using went out of business the next year, turns out they were doing the same thing to alot of people.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
