Posted by Jerry/MT on February 15, 2009 at 20:14:59 from (206.183.116.129):
In Reply to: O/T Turbo Chargers posted by John B. on February 15, 2009 at 18:28:09:
A lot depends on the configuration of the exhaust pipe (side or rear facing exhaust area or even just a vertical stack) and the engine. If a lot of cases, the pressure at the exhaust pipe is slightly less that the pressure at the air intake of the engine. That differential in pressure can drive the flow.
If at least one of the cylinders has an open intake and exhaust valve then flow will go through the air intake through the compressor, into the cylinder with open intake, out the exhaust spin the turbine and exit the exhaust pipe. Since most of these turbo's don't have their own oil supply and pump, they dry windmill and the bearings can be damageddue to running without oil.
The big IF is: does the engine have a position where an intake and exhast valve are open on the same cylinder? If it doesn't then I'd say no problemo!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Best Tractor? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew quite a bit of response. We see the question of "Which tractor is best for me?" asked quite often. We thought you might find the responses interesting. As always, the names of the people participating in the discussion have been left out - we did not request their permission to reprint their names in this article. However you can find this discussion in it's entirety in the Tractor Talk archives.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
