Posted by Doug Steinbach on February 14, 2009 at 03:20:40 from (71.154.9.106):
In Reply to: Re: OT - GFCI posted by IaGary on February 13, 2009 at 16:06:30:
There is only way to correct this and still maintain the GFCI protection of BOTH outlets, AND have them operate independantly of each other.
1. turn off your breaker. 2. remove both outlets from the boxes. (do not remove the wires yet) 3. Identify which of the 2 receptacles has 2 sets of wires attached to it. (that's 2 blacks and 2 whites)
on the outlet that has 2 sets of wires attached to it - is one set of wires attached to screws at the top of the receptacle (load side) and 1 set attached to the bottom set of screw (line side)
if so, remove the set of wires from the screw terminal labeled as LOAD. this WILL be identified on the back of the receptacle - and place them under the screw terminals labeled as LINE. you will now have 2 sets of wires on the line side of this GFCI. the screw terminals are labeled which is black and which is white
If the other receptacle has only one set of wires (1 black - 1 white) then you are done.
However, GFCI number 2 (the one with one set of wires) should have been the one that has been tripping. If I were you I would replace it. also make sure the ground wires are connected on each of the GFCI's
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
