Posted by Sagebrusher on February 13, 2009 at 11:49:58 from (69.19.14.28):
In Reply to: OT-Balistics question posted by Bill Porter on February 12, 2009 at 20:13:07:
Bill, For this and other in-depth answers to your question I recommend you buy or borrow a copy of "HATCHER"S NOTEBOOK" by Julian S Hatcher, Maj Gen U.S.A.(ret.)(now deceased)) ISBNO-8117-0614-1 See Chapter XX "Bullets from the Sky" Gen Hatcher calculated through mathematical means verified by live fire that the 150 gr .30 cal M2 bullet fired at a 90 dgree angle with a mv of 2,700 fps would acheive a maximum height of around 9,000 feet. The bullets took approximately 18 seconds to reach max altitude and an average 31 seconds to return for roughly 50 seconds to return after firing. The return times and velocity were dependant on whether the bullets returned base down (the fastest return) or tumbled end over end (the slowest.) Gen Hatcher felt that during the last few thousand feet of fall that the bullet's return was at a constant 300 fps with an attnedant 30 foot pounds of energy. Bullets with higher ballistic coefficients travel higher/farther and thus take longer to return. Most of the casualties you hear and read about are produced by ignorant buffoons haphazardly firing weapons at less than perpendicular angles resulting in arcing trajectory curves where the bullet remains point on with, usually, more velocity than a bullet returning to earth in freefall mode.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
