|
Tractor Talk Discussion Board |
Re: Plow for Farmall 1206
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Grove r on June 06, 2000 at 18:33:13 from (161.184.18.239):
In Reply to: Plow for Farmall 1206 posted by Jim Frediani on June 04, 2000 at 04:59:21:
There are two basic types of plows, fast turn, or stubble bottoms, and slow turn, or sod bottoms. the stubble bottoms have the share at a more aggresive angle to the ground, and the molboard is shorter with less curve, this configuration lets you travel faster, the material being turned is thrown to the gound harder and more straight down having a shattering effect which makes for less after tilling. I have a four sixteen Oliver plow with stubble bottoms that I pull with ease at six plus miles per hour in stubble and it does an excelant job,[the soil here is sandy clay, and I use an 806]. In sod, this plow pulls like a cat by the tail across the carpet, [just an expression],and the best speed is about four mph. Sod bottoms have a flatter share and a longer more curving molboard. Traveling too fast with these will toss the furrow too far instead of turning it over and laying it flat. These plows are patterned after the bigger and heavyer breaking plows. Their designs are very much the same because they cut roots and have to turn an unbroken strip of material. Of course all plows are not created exactly alike, and there are lots of differnt designs, the two types mentioned are more notably the extremes in designe with lots af variations in between. Hope I haven't confused or discouraged you in any way, this was not my intent .The plow is one piece of farm machinery that is probably the most missunderstood. Properly hitched with sharp shares and used for the conditions it was designed does not pull hard at all, but the extra power you might have is not at all detrimental, better too much than not enough. wishing you every success in your new indeavers G.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Implements and Their Use - by Curtis Von Fange. Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he reached his early sixties
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|