I built a 4 x 8 welding table out of 1/2 inch plate. 5/8" or 3/4" plate would have been even better. I can tack stuff on it and also heat and pound things on it. Any thinner would get warped. A nice flat table is really nice for fitting projects together. Under the table I made a 4 inch channel frame that's in about 8 inches from the edge with a center cross member as well. I welded it with MIG and put staggered welds about 2 inch inches long every 8 inches or so to join the frame to the top. I made sure to suck the top tight to the frame to keep it flat. The staggered welds were so that it wouldn't warp from the heat. I saw a table someone made out of 3/8" plate that was warped really bad because the put a continuous weld along the length of it when joining it to the frame. I designed it so I had to buy the least amount of steel. The legs are square tubing and I mounted 4 locking swivel casters with a large piece of ready rod on them. I welded a big nut on the bottom of the legs for the ready rod to thread into and use a jam nut to lock it in place. This way I can level the table exactly how I want it. I mounted a tubing bender on one corner and it has to be level to get accurate, straight bends. In the opposite corner I mounted a big vice. There is smaller tubing joining the legs together that doubles as a support for a bottom shelf. I also made a drawer out of 1/8" plate for it for putting tools in. I can stand in the drawer. The table weighs 1000 lbs. I built it about 10 years ago and it cost around $400 or $500 for the steel if I remember right. It's easy to roll around but is a real pain if you have to pick it up. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors, A Woman's Touch - by Teri Burkholder. I thought I would give you a little background on how I got myself hooked on tractors and their restoration. My family is a very "crafty" bunch of people. By crafty I mean good with crafts!! My Dad is a retired industrial engineer from Bucyrus Erie which made big shovels for excavating and he is also a wonderful wood worker. My mom and my "guardian angel" has had her own ceramic shop for 30 years and is an excellent painter. With these skills always active in our house it was hard not t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
