I've heard to use a pumice stone like you use on your feet. Never use emery cloth though. It will cause unwanted arcing. Hobart made good generators. If you need new brushes, a carbon brush supplier can make some up for you. I had an old Hobart from the 40's and had brushes made locally. Not really expensive at all. They can test the old brushes to see what composition they are by their hardness and colour I think. The place up here specialiized in brushes and knew pretty much what to use for each application. The machine I had had an electric motor on one side and the welding generator on the other end. It also had an extention on the shaft so a gas engine could be hooked up. Who ever had it before me mounted it on a trailer and powered it with a Chrysler IND 251 ind. engine, probably out of a combine. The fine current control came out and you could put an extension cord on it for a remote control. There was a name for these welders but I forget. I saw an old ad for one on the net. Good welder. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.