Posted by Mark - IN. on February 02, 2009 at 20:26:22 from (205.188.117.74):
In Reply to: Re: Barn steel roofing posted by Paul in MN on February 02, 2009 at 20:10:47:
Hey Paul, its about helping out or ideas. Purlins are what, 1"x3" or 4"? Maybe even 2x's. I would be trying to frame out around it to fill in the gaps and then fastening more 1"x3" or 4" to the purlins over them to support it, even if I had to put one or two down the length of the plexiglass to make up for the lost strength of the ribs in the fiberglass if I had to. Again, someone aint going to like it, someone more knowledgable about it...but I aint replacing that roof if I don't have to. You're welcome, and much good luck. Maybe someone else will have a much better idea, and that's not bad either. Hope something works out for you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
