Posted by John T on February 02, 2009 at 07:52:09 from (98.115.40.108):
In Reply to: starter solenoid posted by Paul Stephenson on February 02, 2009 at 06:59:55:
A typical what I call FORD type electrical solenoid relay/switch has 4 terminals (2 big 2 small).
(MY guess is you have a Ford type solenoid/relay that uses an I terminal that you can simply ignore n not use)
On the Ford type 4 terminal solenoid/relays:
The two big post/studs, that have big honkin cables or one side to starter, are the input from Battery and output to Starter,,,,,,,,The two small terminals are S (Solenoid) and I (Ignition). On those the metal mounting serves as the case ground return. Its the S terminal (receiving voltage from a start switch) that energizes the solenoid to latch/close n crank the starter while the other I terminal which is hot ONLY when the solenoid is energized, might be used to by pass an ignition ballast resistor.
IF YOU HAD ONLY A 3 TERMINAL (No S terminal) AND WANT TO USE THAT 4 TERMINAL, SIMPLY IGNORE THE I TERMINAL. Connect the start switch (hot when in start position) to the S terminal.....
Other possibilities could be a 4 terminal that DOES NOT have any I terminal but one of the lil terminals is the ground return versus the case/frame as in typical Ford type solenoids. It could have like an S terminal while the other is ground and NOT have any I type terminal. If thats the case wire the lil S terminal to the Start switch output and if the other is indeed a ground return terminal, it would connect to frame ground
Figure out what type solenoid you have and let us know...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
