Posted by Jim H SW-PA on February 01, 2009 at 21:26:51 from (98.17.221.150):
In Reply to: Blem tires posted by davediehl@hotmail.com on February 01, 2009 at 00:23:01:
Blemished tires are ones that may have not flowed in the mold right, because of the holes in the mold called "vents" may have been plugged from a previous tire and the rubber whiskers ,or teats didn't push out, causing a flow direction inside the mold to redirect to another vent sometimes causing a crack, or a blister in side wall not bad enough to junk it, so we would take them and grind out the section , replace with uncured rubber and put them in a POT " fancy name for a mold looking thing that was larger than the tire that was repaired." and cook for another 20 min.
This action made the tire a little harder than 1st grade spec,s and could not be sold as 1 st grade.
When I worked there I would buy my own tires and recook them, just to make them run longer.
If you have more questions I'll Email you. there are other repairs we made but long story.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
