Tractor Talk Discussion Board |
Re: Kubota F2400 Drive Shaft
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on May 25, 2000 at 12:55:43 from (209.114.18.144):
In Reply to: Kubota F2400 Drive Shaft posted by Paul on May 25, 2000 at 06:55:36:
I'm not familiar with that tractor, so I can't answer you directly. However, in situations like this, I guess I weigh the benifits vs the damages. If all the parts are already damaged, you might not hurt anything. However, if the shaft is still good, maybe you will end up ruining that too yet. Or the like. The calendar makes a difference for me as well. In August I tend to try to limp along until the end of the season. In May I tend to feel the season is just begining and I might as well get things fixed right instead of worrying about it all summer. Have you looked at it closely? Maybe all is well, with the broken pin the splines may have just slipped out of place. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|