Sounds to me like you need more of plow blade than a bigger bucket. Like a V plow used on road graders or put a reversible and adjustable angle blade with 3 point attachment. You'd need to weld a 3 point set up to your bucket or use an adjustable blade with a skidsteer mount. Just push your way through. Then clean up the trailings and stuff close to the buildings later with the bucket.
But then I'd use the bucket as a plow anyway to push it. Take to long to move snow a bucket full at at time. I have the same problem as the others, bucket won't hold a position and wants to dig in or ride above. Then I end up with a series of furrows from raising and lowering the bucket all the time. And it seems like the loader isn't quite level either.
I used up the bridge planks I had, but I've been meaning to make a blade out of 2 bys or timbers or railroad ties and chain them to the bucket or make a bracket. Then put a brace in the left side of the bucket to hold that side out at an angle for a home made blade.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
