|
Tractor Talk Discussion Board |
Re: Re: Re: Installation of Ballast resistor in ignition circuit
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on May 25, 2000 at 04:37:39 from (206.228.214.108):
In Reply to: Re: Re: Installation of Ballast resistor in ignition circuit posted by Scott Green on May 25, 2000 at 03:07:02:
Scott
I do not doubt that you have converted tractors to 12 volts and maybe they ran fine. However, a ballast resistor goes in the switch/ignition to coil wire and a dropping resistor goes between the 12 volt and the 6 volt components.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
