Hello 37 chief, I just need to add some more on my post, to make it a bit clearer. The 125 torque setting on my example will give you 103 ft. Lb. at the fastener, because the lenght of the torque wrench was 2.56 in is longer. In other words it takes only 103 Lb. pressure, with the extension of 2.56 in., to achieve 125 L. Ft. at the fastener. It also meas that to get 125ft. lb. at the fastener you need to set the torque wrench at 103 Ft Lb. Longer leverage, less effort For a given torque. Also it does not matter if the socket has an extension to the torque wrench. If the extetion is a crowsfoot, and the head of the torque wrench is perpendicular, not offset to the fatsner, no change in torque applied. If it is offset and makes the lenght of the torque wrench longer, from the sockethead of the torque wrench to the handle, than the formula that i gave you applies. Also dry threads are not torqued the same as oiled threads. Usually oiled threads are torqued 10 to 20% LESS! Just fallow the manufaturer specifications. You will find that the type of lubricant changes with the manufaturer, form light engine oil to gear oil. All torque specifications Are for clean threads, wet or dry. Above all, you need to use an accurate torque wrench, steady even pressure while applying torque, and no snappy movements of the arm. In other words steady pressure,let the torque wrench surprise you when it clicks. I hope this makes it clearer for you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
