Easy answers first, I'm 12 miles south of Frankfort on US 127. Right on the Anderson Mercer County line, or thats where I am normally. Im snowed in tonight on the laptop a tad east of there, lol.
The hitch I can tell you from memory, but I sold the rake :( to a guy just down the road a ways. I built it with what I had, pc of 4 inch square tubing that was a foot longer than the width of the rear wheels. I used 18 inch long, 2 pc, of 4 inch C channel bolted to the frame where the tubing would just clear the tires. Then welded it on the bottom of the C channel. Then I used a pc of 3 inch thick wall square tubing inside the 4 inch. Its length, retracted, was even with the outside of the basket on the left side. Then I pulled it out and drilled through both pieces to anchor it retracted, 4 feet out, and 7 feet out. I used some 2.5x 3/8ths flat steel that stuck out 6 inches when welded on the 3 inch square tubing. I designed it as I built it, and have built a few others over the years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
