It is big & takes a lot of resources. Lot more memory.
For using all that you get - not much. It doesn't fill any need, or do anything new, that you couldn't already do with XP.
It was a new product that didn't do anything new for the consumer.
As well when it came out, they threw away a lot of older hardware. Printers, various readers, and so forth just weren't supported. So, folks got tired of buying something new that made all their other hardware obsolete; required more memory & made their computer operate more slowly - all for not actual improvement of anything to the end user.
So, it is a lemon. It probably works ok, and it does a few new things, and it probably tightened up security issues.
But, none of that concerns an end user. It seems like a down-grade to an end user.
The real issue was business users - they have rows & rows of hardware being used by a few 100 people all linked together. When Microsoft came along with Vista, and said well you'll have to buy all new computers because your old ones aren't fast enough; and all new printers and card readers because those companies are not writing new drivers for old hardware; and your own computer support people are saying there is no real benifit to all this expenditure.... Many businesses told Microsoft to take a hike, they will sit this 'upgrade' out.
Most likely by #7 which is supposed to appear in beta in a few months, many companies will again be ready for a hardware upgrade - it's been a long time now......
I remember when Windows 98 and 2000 were out but fairly new, I was going through a few businesses & many were still running Windows 3.1. I was kinda surprised, but then, it's about getting work done for least cost, and if you look ay a few dozen computers, it's pretty spendy to upgrade. For what?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
