Posted by dave2 on January 20, 2009 at 06:58:03 from (139.139.35.70):
In Reply to: Cold chisel posted by Larry59 on January 19, 2009 at 21:00:42:
Matt in WA said: (quoted from post at 22:00:42 01/19/09) Why do they call a "cold chisel", a cold chisel?
I have always found this a very useful tool.
I know there are a lot of machinists that visit this site. Is it because it is cold forged? Thanks for all your answers in advance.
LOOOOOOOOOOOOOONG time ago, there was no distinction.... a chisel by any shape or form was just a chisel.
Then, one Cold, Cold day Bubba and Marcel was out working on the car and had a bunch of chisels in the toolbox. When they set the toolbox up on a snow bank to get it closer to the car, a few of them fell out on the snow/ice. Later on, Marcel told Bubba to get him a chisel. Bubba started fishing and handing until Marcel got frustrated with getting the wrong one and pointed to a big fat one laying on the snow and said "that one ya dummy". Bubba grabbed it and, not having any gloves on, yelped "dam! that's a Cold Chisel......
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
