Saginaw all the way!!! I have one on my 51 H and it was the best thing I did to that tractor! I use the belly pump for lift and gravity for down. I made 2 vent filters out of pipe elbows pointed down to keep water out and filled with some steel wool soaked in gear oil to keep the dust out of the cylinders. It lets the air go in and out when lifting or lowering. There is just one hose going to the lower fitting on the cylinders.Some people have said doing it like that can cause the tool to drop hard, but it hasent happened to me and I have lifted some BIG logs with the boom pole. I can set them down nice and easy. I have a set up on an M with an older after market 3 point with power down force and have mangled hitch equipment bushhogging and grading if the lever gets bumped by a tree limb. Figured the downforce part I just don't need anyway and is good way to break or bend stuff. only problem I have on the H is it goes down slow on cold days till it warms up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.