Posted by old on January 16, 2009 at 08:50:33 from (4.244.186.18):
In Reply to: Carburetor posted by Kenfarmall on January 16, 2009 at 06:52:28:
Well did you ever put any thing in the cylinders before you tried to start it. I.E. like oil, ATF etc. If you didn't then you have a very good chance you have very low compression and if so yep you also get very poor suction so yep gas will not make it to the cylinders. I would put about a !/2 cup of ATF in all the cylinders and walk away from it. One other thing you can try that will also tell you more is pull the air tube off the carb and hold your hand over the carb to see how much suction it has. Shoot it might even start doing that. BTDT and had an Oliver 60 engine that did the same thing. I checked the compression and it was less then 25PSI in all cylinders. Filled them with ATF and let it sit. After a few days compression was up over 100PSI
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
