Posted by 6U684 on January 13, 2009 at 07:53:14 from (67.224.28.37):
Ran across this from a friend: An aluminum/hdrogen fuel cell, to provide power for a motor vehicle
Forbes.com
I will tell you of a method of producing Hydrogen "On Demand." Simply take a stainless steel tank with water, add Sodium Hydroxide, which is common "Red Devil Lye" and then scrap aluminum. The reaction is immediate! The spent aluminum combines with all the Oxygen and falls to the bottom of the tank in the form of a fine powder.
The lye is never used up, although it will suffer a small loss over time through attrition and a little will need to be added occasionally. The result is that Hydrogen is released. Simply connect your generator unit (the stainless steel tank) to an air tank with a popoff valve, then add a valve and run the Hydrogen to the carb, or the air intake, and run your car on pure Hydrogen.
If you have a very small tank it will help a lot. If you produce enough, it will require no gas at all. Any excess Hydrogen will just be vented into the air and not hurt anything. The generator tank will need to be cleaned out ever week or two and is recycleable. Any scrap aluminum will work, even old beer cans, however, beer cans have a coating that slows the reaction and don't have a lot of mass.
A better solution is busted up aluminum transmission cases, etc. Here you have clean aluminum in bulk. In order to run your car on pure Hydrogen, the timing should be set to top dead center because it burns much quicker than gasoline. There are electronic units available on the net for under $40 that will accomplish this from inside your car, so you truly have a dual fuel system. THIS WORKS. Put a small amount in a test tube and prove it for yourself!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
