Posted by rrlund on January 06, 2009 at 12:30:06 from (216.46.212.110):
In Reply to: OT Cattel feeder posted by J Mehaffey on January 06, 2009 at 10:30:51:
Used to be able to buy complete precut hardwood kits for those from the local sawmill. Had some old books here with plans for them,but I don't know where you'd find them online. Called them skidfeeders. Everybody had at least one of'em. All oak,used 2 4x6 skids,16' long. 2x4s across the bottom,then 1xs for a floor. 1xs about 18 inches high for skirt boards. 2x4s in an inverted V shape for the cows to stick their heads in. 1xs to fill in the holes so they couldn't get their heads in the wrong place. 2x4s around the top,one on edge,one laying flat. Hard to draw a picture of it with words.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
