Posted by dan will on January 02, 2009 at 17:13:39 from (206.83.31.147):
In Reply to: JD 3020 stuck in gear posted by Kevin M 17809 on January 02, 2009 at 15:27:02:
Sounds like you will have to manual shift it down below on the transmission housing. Might have to unhook your linkages after you take the cowl off the tractor. Sounds like it needs rebushing kit in your syncro plates. It is not as bad as you think. If you have access to a manual you should be able to follow the guidelines about the adjusting process. I have not worked on a 3020 but our 4020 has had problems in the past. It was money well spent to put new bushings in the plates and after it was adjusted it was shifting like a new one.If I wss guessing you probaly have lost a snap ring off the side of the shaft that holds the lever and syncro plates in place. Sometimes the snap ring just wears out and breaks. Hope this helps you out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
