|
Tractor Talk Discussion Board |
Re: need help on sidewinder mower
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Moye on April 15, 2000 at 18:56:43 from (209.214.99.70):
In Reply to: need help on sidewinder mower posted by Scott on April 14, 2000 at 12:54:58:
Scott, a friend of mine just bought a used sidewinder and asked me to get it to working. The blades aren't that hard to change on this one because there is a hole in the top of the mower behind the blade support that lines up with the bolt that holds the blade on. The bolt is supposed to be flat on one side so it will hold itself while you tighten or loosen it. It takes, I think, a 1 5/8" socket to fit it and probably a long pull handle with a cheater bar, or a good air wrench to take it off. The hole may be covered with a round flap of metal held on with one or two bolts(I can't remember which). Hope this helps. Moye
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
