Posted by glennster on December 25, 2008 at 11:15:57 from (68.60.242.156):
In Reply to: plasma cutter posted by crackerhead on December 24, 2008 at 18:14:11:
i have a thermo-dynamics pak 5 xt air plasma. its an old machine now, but bought it new years ago. still cuts good. consumables, air cap and electrodes do get pricey. works great for long straight cuts on flat steel. mine is a 1/2 inch capacity. i made a little jig that the gun snaps in to, so it holds the tip about 1/8 inch off the material being cut. had a flat side on it so it can rest against a fence when cutting 4x8 sheet steel. tips last a lot longer, seem to stay cleaner too. they do have a drag cutting cap for the torck, but they seem to clog up pretty quick.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
