Posted by bc on December 24, 2008 at 18:20:04 from (68.88.175.43):
In Reply to: gas furnace posted by Don c on December 24, 2008 at 06:23:00:
Lowes sells furnaces now if you are up to it. Seems like about $800 for an 80,000 btu. Kinda depends upon if you can handle moving the air conditioner coil if it has one and any changes needed in the duct work from a different size unit. Different brands are different sizes and may require changing the return and out going duct work as well as the filter frame.
Most repairman won't fix old furnace and a/c's unless it is a thermocouple or valve or a small circuit board assuming they stock one. Better to sell a new one with a 100% markup plus labor and ductwork.
Its a no win situation for repairman, tell you a new one is needed but you opt for a $300 repair. Then a couple years later when the unit finally goes bad for good, the repairman gets blamed for a faulty repair or not stressing to you enough that you are throwing good money after bad when you repair it and don't replace it. Kinda like the decision you make when the engine blows on your 1985 Honda civic. Do you spend a few grand overhauling it or tow it to the junk yard?
Buy the carbon monoxide detector as a christmas no matter what if you care for her. Get the kind that are wired in so you have one in the furnace room and her bedroom. Then equip her house with smoke detectors wired together with one above the electrical panel, the basement rooms, the bedroom and any doorways and hallways between her and an exit. Then get her a weather alert radio. Easy Christmas and birthday shopping for the loved ones who have everything except the things that may save their lives.
As the others said, a hole in the combustion chamber is deadly. A rusted baffle or even a rusted housing not so bad but indicative of a furnace on its last leg. If she is rich, the decision is easy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
