Re: Re: Repair of Egged-Out Fittings.

Posted by Tom R on April 13, 2000 at 18:36:45 from (206.158.251.29):

In Reply to: Re: Repair of Egged-Out Fittings. posted by Fred on April 13, 2000 at 07:06:25:

I go along with Fred on this. I have had fairly good results with welding around either a piece of carbon, brass or copper rod slightly larger than the pin, this will leave you with very little grinding to do. The weld won't stick to any of the materials mentioned so it will do a fair job of maintain the hole and you can remove it when you are through welding . I would probably get a brass rod turned to a diameter that would give the pin clearance you need and then put it through the holes on both sides to assure your bore alignment will be straight, then weld around the rod as needed.
Tom R.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Repair of Egged-Out Fittings. Comments: Optional Link URL: Link Title: Optional Image URL:

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]