Posted by Funtwohunt on December 19, 2008 at 21:45:19 from (63.172.252.161):
In Reply to: 3 point snow throwers? posted by Gun guru on December 19, 2008 at 14:49:06:
8' wide, double augers, gear box rated at 60 hp. We put on a tall shute on it so I can blow into trucks after it's windrowed to center of street. Windrows about 4' tall and 6' wide work best. Power it with a IH 966 Hydro. chained up. If I have good drivers and the snow is just right I can load 3 - 16' farm trucks that have 6' sides and with end gates (just like we used to use cutting silage)in less than ten minutes total. In the early 1970's they tried to use it on a IH 1466 Reg. trans, JD 4430 Quad Range, Case 1070 Powershift and they were all too fast in reverse. The blower sat in a fence row until 1984 or so until I convinced someone to try a hydro. Tried out the the 966 and bought it the next day. Works perfect for any condition. If I push it I will shear a bolt or two. I have ran this set up every year since. In the late 80's and early 90's when we got a lot more snow we loaded about 100 loads a day for two or three days straight. Last year I took out 1 bearing when I hit a chunck of cement in the windrow. Only thing we have ever done to it. Later, Funtwohunt
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
