Posted by buickanddeere on December 18, 2008 at 21:59:15 from (216.183.133.117):
In Reply to: Re: pump trips breaker posted by showcrop on December 18, 2008 at 19:45:55:
As Henry said. If that is really a 240v pump. Both the white and black have 120 to neutral on them. And 240V between the white and black wires. The bare copper should be connected to the switch's metal frame/body. Time to megger the pump motor and find out if it's shorted to ground. Then use an ohm meter to check for shorted windings. A high voltage surge or spike while lines fell on each other may have damaged the motor. Odds are the pump will have to come up. New pumps have a simpler/more reliable three phase motor down the well. And a variable speed drive that converts your hydro service's single phase to three phase at the top of the well for the motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
